Take out the printer from the sealed box with all its key components i.e. cables, cartridges, etc.
The next thing to do is, remove the polystyrene packaging wraps with the orange tapes along with the plastic covering from the printer.
The first thing for hardware setup is to find out the power socket on the printer. As mentioned in Canon Ij Setup guide, plug the power cable to the wall socket and then to the printer’s port.
After that, switch the printer on by pressing the power button. And you will find the printer’s display light on.
For inserting the ink tanks, remove the cartridges outlet seal and the plastic covers covering it.
The printhead carriage will adjust itself once you open the top cover of the printer. Put all the cartridges and put them into their correct slots.
After putting the cartridges into the slots, close the printer top cover and suddenly you will observe that the printer will start making noise. This is the indication that ink cartridge installation is successfully done.
After then, open the flap of the printer and then pull out the input tray and then, put some pages into the paper tray.
Put the paper tray back to its place properly.
This finally finishes the configuration of your Canon Printer via canon.com/ijsetup.
How to Unbox the Printer?
Are you purchasing a printer? When you buy a printer,there are certain mandatory steps you need to follow prior to printing. One such step is the unbox setup. Follow the steps below for the process.
Step 1:Unpack the printer
Prior to unpacking, examine the list of contents in the shipment box as it may vary by country/region.
Truncate the printer. Discard all the packing materials in the exterior of it. Pull the output tray out. Look at the interior of the printer.
Hold the handles of the ink cartridge access door to unseal it. Eradicate all the packing materials from the interior of the printer.
After discarding them,seal the cartridge access door. Take out all the hardware in the box prior to discarding it.
Plug in one end of the power cable to the hind-side of the printer and the other end to the wall socket.
Once you are done with the connection process, switch on the printer. To on it, press the power button on the front panel.
Step 2:Install the ink cartridges
Ink cartridges are necessary for the printing process . Utilize genuine ink cartridges that are compatible with the printer model.
Clutch the handles and then pull the ink cartridge access door to unlock it. Wait for the carriage to slide to the middle of the printer.
Take out the new cartridges from the printer’s package. Be cautious to touch only the black plastic on the ink cartridge.
Eliminate the plastic tape. While holding the ink cartridge,you should not touch the ink nozzles.This may result in ink failure.
Grasp the ink cartridge by its sides with the nozzles facing the printer. Install the ink cartridge into its slot.
Push the ink cartridge at an upward angle into the empty slot , shove the ink cartridge until it fixes into place. After installation , seal the door.
Step 3:Load paper into the tray
Without a paper, you cannot get the hard copy for your messages. When you use a paper,make sure that it is not bend or stapled.
Heave the input tray. While feeding the paper into the input tray,ensure that it is compatible with the printer.
Move the paper width guides to their farthest position.Feed a stack of paper into the input tray.
Place the paper with the short edge moving forward and the print side facing you. Shove the stack until it stops .
Adjust the paper width guides to the right until it snaps against the edge of the paper. While adjusting , make sure that you do not bend the edges.
Once you are done with the above steps,pull the output tray and tug out the output tray extender.
Regards, J Wick